Tiida D1592 brake pads are installed as follows:
1. Before replacing the Tiida D1592 brake pads, you should open the cover of the brake fluid reservoir in the engine compartment and check the height of the brake fluid page. If the brake fluid page is above the maximum limit, you should suck out some brake fluid. To prevent the brake fluid from overflowing during the replacement process;

2. Prepare the Tiida D1592 brake pads to be replaced and remove the wheel where the brake is located. Avoid scratching the rim during dismantling;
3. Use a wrench combined with the sleeve to remove the bolt of the brake caliper, and then remove the brake pad (if there is a brake sensor line, remove the brake sensor line first). Observe whether the brake pads are excessively worn or cracked, and if so, replace them in the next step;
4. Since the brake caliper will have a lot of sand or mud, it should be cleaned with a rag, and then applied with silencer paste to prevent abnormal noise when braking;
5. Use the piston pressure pump to press the piston to the position where it cannot be pressed, then install the Tiida D1592 brake pads on the brake caliper, and install the new brake pads in place (the ones with brake sensing lines should also be installed), turn Tighten the guide bolts and the installation is complete;
6. After the installation is complete, cover the lid of the fluid tank, step on the brake pedal a few times in the car, and reset the brake. Then observe the brake fluid height, it should be within the appropriate height range;
7. After replacing the Tiida D1592 brake pads, test the car to check whether the braking effect is reflected.