How to replace Volkswagen Touareg D1349 brake pads? Here's a quick guide on how to replace it:

1. Before replacing the Volkswagen Touareg D1349 brake pads, open the cover of the brake fluid storage tank in the engine compartment to check the height of the brake fluid level. If the brake fluid level is above the maximum limit, you should suck out some of the brake fluid , to prevent the brake fluid from overflowing during the replacement process;
2. Prepare the brake pads to be replaced, and remove the wheel where the brake is located. Avoid scratches on the rim during disassembly;
3. Use a wrench combined with a sleeve to remove the bolts of the brake caliper, and then remove the brake pads (if there is a brake sensing line, first remove the brake sensing line). Observe whether the Volkswagen Touareg D1349 brake pads are excessively worn or cracked, and if so, replace them in the next step;
4. Since there will be a lot of sand or mud in the brake caliper, it should be cleaned with a rag, and then apply sound-absorbing paste to prevent abnormal noise when braking;
5. Use the piston pump to press the piston to the position where it cannot be pressed, and then install the brake pad on the brake caliper. After installing the new brake pad in place (the brake sensor line should also be installed), tighten the guide Bolts are installed;
6. After installation, cover the lid of the liquid storage tank, step on the brake pedal a few times in the car, and reset the brake. Then observe the height of the brake fluid, which should be within the appropriate height range;
7. After replacement, test run to check whether the braking effect is reflected.
This is about the replacement method of Volkswagen Touareg D1349 brake pads. I hope it will be helpful to you.